CITB HS&E Operatives: High-risk activities practice questions

Written by Acacio Oliveira, founder of FreeMocks, plumbing and heating engineer (F-Gas registered).

72 of our 300 CITB Health, Safety and Environment Test: Operatives (CITB-HSE-OPS) questions are on high-risk activities, about 24% of the bank. Try 6 below with full worked answers, then practise the rest in a timed mock.

Practice questions

Pick an answer to see why it's right, why the others are wrong, and the page in the book.

Q1. Why are roof lights a particular hazard during roof work?

Show answer

Answer: B. Some are hard to see in certain light, and some are painted over

  • Roof openings and fragile roof lights are a particular hazard.
  • Some are hard to see in certain light; others are hidden by paint.
  • Protect them with barriers or covers that are secured or labelled.

You cannot avoid what you cannot see.

Why the others are wrong:

A: burns are not the hazard described.

C: roof lights are often fragile.

D: they can be hard to see in daylight too.

Memory trick:

Painted-over roof light, hidden hole.

Find it in the book

HSE HSG150 (3rd ed), page 47

Reg HSE HSG150, para 243

Q2. You are asked to clean a canopy glazed with wired glass by standing on it. What should you assume about the glass?

Show answer

Answer: C. That it is likely to be fragile and must not be stood on

  • Likely to be fragile: roof lights, liner panels, non-reinforced fibre cement sheets, corroded metal sheets.
  • Also glass (including wired glass), rotted chipboard, and slates and tiles.

Wire in glass does not make it strong enough to stand on.

Why the others are wrong:

A: HSE lists wired glass as likely to be fragile.

B: spreading your weight does not make fragile glass safe.

D: short duration does not make a fragile surface any stronger.

Memory trick:

Wired glass is still glass.

Find it in the book

HSE INDG401(rev2), page 3

Reg Work at Height Regulations 2005 (HSE INDG401)

Q3. What are the main causes of accidents during roof work?

Show answer

Answer: D. Falls from roof edges and through holes, roof lights and fragile surfaces

  • Roof work is high risk: falls from roofs and through fragile roofs and roof lights are among the most common causes of workplace death and serious injury.
  • The main causes are falls from roof edges and falls through holes, roof lights and fragile surfaces.

Many of those killed were only repairing or cleaning roofs, not specialist roofers.

Why the others are wrong:

A: these are health risks, not the main accident causes named.

B: this is not named as a main cause of roof accidents.

C: manual handling injuries are not named as the main cause.

Memory trick:

Off the edge or through the roof.

Find it in the book

HSE HSG150 (3rd ed), page 44; HSE INDG401(rev2), page 3

Reg HSE HSG150, para 230; HSE INDG401, What are the most common causes of accidents when working at height?

Q4. A cable has been located and marked. How close to the indicated line can a mechanical excavator be used?

Show answer

Answer: A. No closer than 0.5 m

  • Mechanical excavators and power tools should not be used within 0.5 m of the indicated line of a service.
  • Final exposure should be by careful hand digging, ideally alongside the service.

Most cable strike injuries involve shallow cables and powered tools.

Why the others are wrong:

B: this is too close; the guidance gives 0.5 m.

C: going slowly does not make machine digging safe near cables.

D: this is far more than the 0.5 m stated in HSG150.

Memory trick:

Half a metre: hands only.

Find it in the book

HSE HSG150 (3rd ed), page 76

Reg HSE HSG150, para 377

Q5. On an industrial roof, can a pack of roof sheets be used as a platform while laying the first sheets?

Show answer

Answer: C. No, a separate platform may be needed

  • Plan how the first sheets will be laid.
  • A pack of roof sheets is not a safe working platform; a separate platform may be needed.
  • Plan how sheets will be raised to roof level, eg by crane or inclined hoist.

The first sheets are often where the leading edge is most exposed.

Why the others are wrong:

A: its position does not make it a safe platform.

B: a pack of sheets is not a safe working platform.

D: a pack of sheets is never a safe working platform.

Memory trick:

A pack is not a platform.

Find it in the book

HSE HSG150 (3rd ed), page 48

Reg HSE HSG150, para 248

Q6. Bricks are being stacked on a scaffold platform that has a toe board but no brick guards. How high can they be stacked?

Show answer

Answer: B. No higher than the toe board

  • Do not stack material on scaffolds unless needed.
  • Not above the level of the toe board unless brick guards or another way of retaining material is fitted.
  • Tie down loose materials and scaffold boards if high winds are possible.

Bricks above the toe board can fall straight through the guard rails.

Why the others are wrong:

A: stability of the stack does not stop bricks falling off the edge.

C: HSG150 links the height to the toe board, not to 1 m.

D: without brick guards, stacks above the toe board can fall through gaps.

Memory trick:

No brick guard? Stack no higher than the toe board.

Find it in the book

HSE HSG150 (3rd ed), page 107

Reg HSE HSG150, para 556

Want 294 more CITB HS&E Operatives questions? Start a free timed mock.

Start a free mock

Full mock, no card needed. Full workouts on the first 5 questions.

Other CITB HS&E Operatives topics

Free official guides for this topic

Our questions are written from these documents. Download them free to revise from the source.

© Crown copyright (HSE). Unchanged copies, reproduced under the Open Government Licence v3.0. FreeMocks is not connected to or endorsed by HSE or the government.

Revise this topic