The AM2 exam explained: AM2, AM2S and AM2E assessments
Updated 11 October 2026. Written by Acacio Oliveira, founder of FreeMocks, plumbing and heating engineer (F-Gas registered).
The AM2 is the practical end-point assessment that stands between you and qualified electrician status. It is run by National Electrotechnical Training (NET) at approved centres around the country. Over about two and a half days you install, inspect, test and fault-find on a rig, then sit a one-hour online knowledge test.
This guide covers which version you sit, what each section involves, how long you get, what happens if you fail a section and how to prepare. Always check the current details with NET and your centre: they set the rules, and they do change.
AM2, AM2S or AM2E: which one do you sit?
There are three versions. Which one you sit depends on how you trained, not on choice.
| Version | Who it is for | Notes |
|---|---|---|
| AM2 | Learners on the Level 3 NVQ (City & Guilds 2357 or EAL 1605) | The final unit of the NVQ. No containment work |
| AM2S | Installation and Maintenance Electrician apprentices who started before September 2023 | Includes containment |
| AM2S v1 | Installation and Maintenance Electrician apprentices registered from September 2023 | Longer knowledge test: 45 questions in 1.5 hours |
| AM2E | Experienced workers on the Experienced Worker Assessment, once they hold the Experienced Worker Qualification | Candidates registered from 4 September 2023 take AM2E v1 |
| AM2D | Domestic Electrician apprentices | 19-hour practical, 90-minute knowledge test and an interview |
| AM2ED | Experienced domestic electricians on the domestic Experienced Worker Assessment | 19-hour practical and 90-minute knowledge test |
NET groups them into two families: installation and maintenance (AM2, AM2S, AM2E) and domestic (AM2D, AM2ED). Within each family the content is very similar, and the letters mainly tell NET who is taking which assessment. Ask your training provider if you're not sure which one you're registered for.
The sections and how long you get
NET's checklists set the sections out like this. The original AM2S follows the AM2E pattern; the AM2S v1 has longer slots for A1, the installation and the knowledge test.
| Section | What you do | AM2E (original) | AM2S v1 |
|---|---|---|---|
| A1 | Safe isolation, risk assessment and planning | 45 minutes | 1 hour |
| A2 to A6 | Composite installation: consumer unit, lighting and power circuits, a motor circuit and containment | 10 hours | 10.5 hours |
| B | Inspection, testing and certification | 3.5 hours | 3.5 hours |
| C | Safe isolation of circuits | 30 minutes | Not listed as a separate section |
| D | Fault diagnosis and rectification | 2 hours | 2 hours |
| E | Assessment of applied knowledge (online test) | 1 hour, 30 questions | 1.5 hours, 45 questions |
The installation is the longest part and the one most people run short on. You work to a written specification and drawings, and it is marked against them. One of the most common reasons for failing is not reading and following the specification, so read it twice before you pick up a tool.
Section E: the online knowledge test
Section E is a computer-based multiple-choice test. On the AM2, original AM2S and AM2E it is 30 questions in one hour. On the AM2S v1 it is 45 questions in 1.5 hours, also covering installation practice, fault diagnosis, design and planning, and behaviours such as customer service, and you're given BS 7671, Guidance Note 3, the On-Site Guide and the Electrician's Guide to the Building Regulations. The core areas are:
- Health and safety
- BS 7671: Requirements for Electrical Installations
- The Building Regulations
- Inspection, testing and fault finding
They are applied questions, not straight recall. Expect things like the order of tests on a ring final circuit, what a reading tells you about a fault, or which regulation applies to a situation on site. NET does not publish the pass mark in its candidate checklist, so ask your centre.
Before you book: the readiness checklist
To book, you complete NET's candidate checklist for your version, have it signed and send it to your chosen assessment centre, not to NET's head office. It must be the whole document with no pages missing, and NET accepts signatures dated within six months of the gateway application.
Treat the checklist as a revision plan. It lists what you need to be able to do in each section, so any line you can't honestly tick is something to practise first.
How much the AM2 costs
These are NET's recommended prices. Centres can set their own, so always check before you book.
| Version | Recommended fee |
|---|---|
| AM2 | £885 |
| AM2S (started before September 2023) | £965 |
| AM2S v1 (registered from September 2023) | £1,340 |
| AM2E (registered on the EWA up to 3 September 2023) | £965 |
| AM2E v1 | £1,235 |
| AM2D | £1,535 (1 April 2026 to 31 March 2027) |
| AM2ED | £1,340 |
Resits are charged per section. For the AM2 and original AM2E, NET's 2026-27 recommended resit fees are £190 for A1, C or E, £265 for B or D, and from £250 for one installation sub-section.
If you fail a section
You don't sit the whole AM2 again. You rebook and resit only the sections you failed, and each resit is charged separately. Fees vary by centre and section, so check before you book. Use the feedback from your first attempt: it tells you exactly where the marks went.
How to prepare
- Download the latest checklist and pre-assessment material from NET and work through every line.
- Practise safe isolation until the sequence is automatic, including proving your tester before and after.
- Run a full set of tests on a circuit at home or at work and fill in the schedule of test results as you would on the day.
- Practise fault finding on a board with known faults: open circuits, high resistance joints and crossed polarity.
- Time yourself on the installation. Speed comes from planning the job before you start, not from rushing.
- Sit timed knowledge mocks so 30 questions in an hour feels normal.
Practise for it
The practical sections need time on the tools. Section E is the one you can practise anywhere. Our AM2 mocks follow the 30-question, one-hour format, with a worked answer for every question, and cover the same core areas as the longer AM2S v1 test.
Frequently asked questions
How long is the AM2 assessment?
About two and a half days. NET's AM2E candidate checklist allows 45 minutes for safe isolation and risk assessment, 10 hours for the composite installation, 3.5 hours for inspection, testing and certification, 30 minutes for safe isolation of circuits, 2 hours for fault diagnosis and 1 hour for the knowledge test. The AM2S v1 allows longer (1 hour for A1, 10.5 hours for the installation and 1.5 hours for the knowledge test), and the AM2 has no containment work.
How many questions are in the AM2 online test?
It depends on your version. On the AM2, the original AM2S and the AM2E, Section E is 30 multiple-choice questions in one hour. On the AM2S v1, for apprentices registered from September 2023, it is 45 questions in 1.5 hours, and you are given BS 7671, Guidance Note 3, the On-Site Guide and the Electrician's Guide to the Building Regulations to use.
What is the difference between the AM2S and the AM2E assessment?
AM2S is for apprentices on the Level 3 Installation and Maintenance Electrician apprenticeship standard (AM2S v1 if you registered from September 2023). AM2E is for experienced electricians going through the Experienced Worker Assessment. NET says the letters are mainly for registration: within the installation and maintenance group the content is very similar and both include containment, so neither is easier.
How much does the AM2 exam cost?
NET publishes recommended prices, and centres can charge differently. For 2026-27 they are £885 for the AM2, £965 for the original AM2S, £1,340 for the AM2S v1, £965 or £1,235 for the AM2E depending on when you registered, and £1,535 for the AM2D. Your employer or training provider often pays for apprentices.
What is the AM2D?
The end-point assessment for the Domestic Electrician apprenticeship. It has a 19-hour practical, a 90-minute knowledge test and a scenario-based interview. Experienced domestic electricians take the AM2ED instead.
Can I resit just one section of the AM2?
Yes. If you fail a section you rebook and resit that section, not the whole assessment. Each resit is charged separately. NET's recommended 2026-27 resit fees for the AM2 and original AM2E start at £190 for sections A1, C or E, so check the fee with your assessment centre before you book.
What do I get when I pass the AM2?
The AM2 is the final assessment on the route to qualified electrician status. With the right Level 3 qualification, your 18th Edition and the ECS health and safety assessment, it makes you eligible for the ECS Gold Card as an installation electrician.
Related
Sources: NET AM2, AM2S, AM2S v1, AM2E, AM2D and AM2ED pages and candidate checklists, and NET's AM2 versions page (fees and times checked 7 November 2026). FreeMocks is independent and not affiliated with NET, City & Guilds, EAL or the JIB. Check current details with NET and your assessment centre.
