Electrical Safety: Safe isolation and working dead practice questions

Written by Acacio Oliveira, founder of FreeMocks, plumbing and heating engineer (F-Gas registered).

30 of our 120 Electrical Safety Awareness (ELEC-SAFETY) questions are on safe isolation and working dead, about 25% of the bank. Try 6 below with full worked answers, then practise the rest in a timed mock.

Practice questions

Pick an answer to see why it's right, why the others are wrong, and the page in the book.

Q1. Which device does HSG85 list as suitable for proving dead on a low-voltage system?

Show answer

Answer: D. A two-pole voltage detector

  • HSG85 lists two-pole voltage detectors, test lamps, or voltmeters with insulated probes and fused leads (see GS38).
  • The instrument must protect against shock and prevent short circuits in use.

Training in using voltage detectors is essential.

Why the others are wrong:

A: HSG85 does not recommend non-contact devices for proving dead on low voltage.

B: a CAT locates buried cables; it does not prove conductors dead.

C: a torch is not a test instrument at all.

Memory trick:

Two poles to prove.

Find it in the book

HSE HSG85 (3rd edition, 2013), page 22

Reg Electricity at Work Regulations 1989, reg 13 (HSE HSG85, para 54)

Q2. Three people are working on the same isolated equipment. What does HSG85 recommend for locking off?

Show answer

Answer: A. Each fits their own lock to a multi-lock hasp and keeps the key

  • HSG85: where several people rely on locking off, use a multiple locking hasp, lock-out box or key-safe.
  • Everyone fits their own lock and keeps personal possession of the key.

The equipment cannot be re-energised until every lock is removed.

Why the others are wrong:

B: a shared key left in place lets anyone re-energise the equipment.

C: HSG85 says each person keeps personal possession of their own key.

D: agreement is not a secure isolation; locks are needed.

Memory trick:

One person, one lock, one key.

Find it in the book

HSE HSG85 (3rd edition, 2013), page 21

Reg Electricity at Work Regulations 1989, reg 13 (HSE HSG85, para 51)

Q3. What does HSG85 say should be the normal approach to work on electrical equipment?

Show answer

Answer: A. Work with it dead; live work should rarely be allowed

  • HSG85: work on or near live exposed conductors should rarely be permitted.
  • Plan work so jobs can be done with the equipment dead wherever possible.

Many accidents happen on equipment that could have been isolated.

Why the others are wrong:

B: saving time is not a reason; live work must meet strict conditions.

C: gloves alone do not justify live work; dead working is the normal policy.

D: the decision follows a set procedure, with dead working as the norm.

Memory trick:

Dead is the default.

Find it in the book

HSE HSG85 (3rd edition, 2013), page 12

Reg Electricity at Work Regulations 1989, regs 13 and 14 (HSE HSG85, para 23)

Q4. A circuit has been isolated by taking out its fuse. What should then happen?

Show answer

Answer: C. Keep the fuse with you or lock the box so it can't be refitted

  • HSG85: if a fuse is removed, make sure it or a similar one cannot be reinserted.
  • Do this by taking it away or locking the box or enclosure until the work is done.
  • Lockable insulating blanks can be fitted in the empty fuseway.

An empty fuseway is an invitation unless it is secured.

Why the others are wrong:

A: anyone could refit it while you are working.

B: this would re-energise the circuit you are working on.

D: a note does not stop the fuse or a similar one being refitted.

Memory trick:

Pull it, pocket it.

Find it in the book

HSE HSG85 (3rd edition, 2013), page 21

Reg Electricity at Work Regulations 1989, reg 13 (HSE HSG85, para 50)

Q5. An old machine is being taken out of use and will be left in place for now. What should happen to its electrical supply?

Show answer

Answer: B. Disconnect it from all supplies, isolate it and label it

  • HSR25: before equipment is decommissioned, dismantled or abandoned, it must be disconnected from all sources of supply.
  • Effective steps must make sure it is dead and cannot inadvertently be re-energised.
  • It may be necessary to label equipment, circuits and switches to prevent this.

Disused kit left connected is a hidden hazard for the next person.

Why the others are wrong:

A: switching off is not isolation; the supply could be switched back on.

C: HSR25 says disused equipment should be disconnected from all sources of supply and isolated.

D: covering the controls does not stop the machine being re-energised.

Memory trick:

Out of use means out of supply.

Find it in the book

HSE HSR25 (3rd edition, 2015), page 37

Reg Electricity at Work Regulations 1989, reg 13 (HSE HSR25, para 199)

Q6. What is the difference between switching off a supply and isolating it?

Show answer

Answer: C. Isolation also stops it being switched back on

  • Regulation 12(1)(a) requires a way to switch off the supply; 12(1)(b) requires a way to isolate it.
  • Isolation ensures the supply stays off and inadvertent reconnection is prevented.
  • Sometimes one device does both, but the two functions are different.

Off is not the same as safe.

Why the others are wrong:

A: HSR25 says switching off and isolation are not the same.

B: switching off applies at all voltages; isolation adds security.

D: isolation applies to any electrical equipment.

Memory trick:

Off can come back on; isolated can't.

Find it in the book

HSE HSR25 (3rd edition, 2015), page 34

Reg Electricity at Work Regulations 1989, reg 12(1) (HSE HSR25, paras 182 to 183)

Want 114 more Electrical Safety questions? Start a free timed mock.

Start a free mock

Full mock, no card needed. Full workouts on the first 5 questions.

Other Electrical Safety topics

Free official guides for this topic

Our questions are written from these documents. Download them free to revise from the source.

© Crown copyright (HSE). Unchanged copies, reproduced under the Open Government Licence v3.0. FreeMocks is not connected to or endorsed by HSE or the government.

Revise this topic