Electrical Safety: Portable equipment, inspection and safe practices practice questions

Written by Acacio Oliveira, founder of FreeMocks, plumbing and heating engineer (F-Gas registered).

30 of our 120 Electrical Safety Awareness (ELEC-SAFETY) questions are on portable equipment, inspection and safe practices, about 25% of the bank. Try 6 below with full worked answers, then practise the rest in a timed mock.

Practice questions

Pick an answer to see why it's right, why the others are wrong, and the page in the book.

Q1. What does INDG231 recommend for the fixed installation (the wiring from the meter to the socket outlets)?

Show answer

Answer: D. Periodic inspection and testing by a competent person

  • The fixed installation is the wiring and equipment from the supply meter to the point of use, eg socket outlets.
  • INDG231 recommends it is inspected and tested periodically by a competent person.

This is separate from portable appliance checks.

Why the others are wrong:

A: fixed wiring needs periodic inspection and testing, not just user checks.

B: INDG231 recommends periodic inspection and testing.

C: PAT is for portable equipment, not the fixed installation.

Memory trick:

Fixed wiring gets tested too.

Find it in the book

HSE INDG231 (rev1, 2012), page 4

Reg HSE INDG231, 'Carry out preventative maintenance'

Q2. A worker using a breaker near a known live cable says, 'It's fine, the cable is insulated.' What does HSR25 say?

Show answer

Answer: B. Insulation won't stop a tool damaging or piercing it

  • HSR25: during excavation, a cable's insulation is not an effective measure against damage or penetration by a mechanical tool.
  • Underground cables can cause serious or fatal injury, especially to people using picks and concrete breakers.

Locate, mark and dig carefully.

Why the others are wrong:

A: HSR25 says insulation is not effective against damage by tools.

C: underground cables present a serious or fatal risk during digging.

D: any cable can be damaged; insulation and armour are not a defence.

Memory trick:

Insulation stops volts, not breakers.

Find it in the book

HSE HSR25 (3rd edition, 2015), pages 39 to 40

Reg Electricity at Work Regulations 1989, reg 14 (HSE HSR25, paras 214(b) and 226)

Q3. You are about to dig near a building. What does INDG231 say you should assume about underground cables?

Show answer

Answer: A. That cables are present, and use plans and a locator

  • INDG231: always assume cables will be present when digging in the street, pavement or near buildings.
  • Use up-to-date service plans, cable avoidance tools and safe digging practice.

HSG47 gives more detailed guidance.

Why the others are wrong:

B: INDG231 says always assume cables will be present.

C: INDG231 gives no safe depth to rely on.

D: INDG231 calls for up-to-date plans, plus a locator and safe digging.

Memory trick:

Assume it's there; prove it isn't.

Find it in the book

HSE INDG231 (rev1, 2012), page 4

Reg HSE INDG231, 'Underground power cables'

Q4. A colleague asks you to rewire a plug. You have never been shown how. What is the right approach under INDG231?

Show answer

Answer: C. Don't; even a plug needs competence to avoid danger

  • INDG231: make sure people working with electricity are competent.
  • Even simple tasks such as wiring a plug can lead to danger, so people must know what they are doing before they start.

Ask to be trained, or leave it to someone competent.

Why the others are wrong:

A: INDG231 says even simple tasks like wiring a plug can lead to danger.

B: the fuse rating does not make an untrained person competent.

D: RCDs detect some, not all, faults.

Memory trick:

Not trained? Not your plug.

Find it in the book

HSE INDG231 (rev1, 2012), page 4

Reg HSE INDG231, 'Work safely'

Q5. Portable tools on construction sites are often designed to run from which reduced-voltage supply?

Show answer

Answer: C. 110 V centre-tapped to earth

  • INDG231: portable tools designed for a 110 volt centre-tapped-to-earth supply are readily available.
  • HSR25: reduced voltage suits portable tools and construction sites.

Centre-tapping keeps the voltage to earth low.

Why the others are wrong:

A: this is normal mains voltage without protection, not a reduced supply.

B: this is higher than mains, not a reduced voltage.

D: this is the boundary of high voltage, not a site tool supply.

Memory trick:

Site tools: 110, centre-tapped.

Find it in the book

HSE INDG231 (rev1, 2012), page 3

Reg HSE INDG231, 'Reduce the voltage'

Q6. Two lengths of flexible cable need joining. What should be used?

Show answer

Answer: B. A proper cable connector or coupler

  • INDG231: use proper connectors or cable couplers to join lengths of cable.
  • Do not use strip connector blocks covered in insulating tape.

Regulation 10 needs every joint to be mechanically and electrically suitable.

Why the others are wrong:

A: INDG231 says not to use strip connector blocks covered in tape.

C: this is not a proper connection and can easily fail.

D: INDG231 calls for proper connectors or couplers.

Memory trick:

Couple it, don't tape it.

Find it in the book

HSE INDG231 (rev1, 2012), page 2

Reg HSE INDG231, 'Provide safe and suitable equipment'

Want 114 more Electrical Safety questions? Start a free timed mock.

Start a free mock

Full mock, no card needed. Full workouts on the first 5 questions.

Other Electrical Safety topics

Free official guides for this topic

Our questions are written from these documents. Download them free to revise from the source.

© Crown copyright (HSE). Unchanged copies, reproduced under the Open Government Licence v3.0. FreeMocks is not connected to or endorsed by HSE or the government.

Revise this topic