CITB Highway Works: Core: general safety practice questions

Written by Acacio Oliveira, founder of FreeMocks, plumbing and heating engineer (F-Gas registered).

16 of our 200 CITB HS&E Specialist Test: Highway Works (CITB-SPEC-HIW) questions are on core: general safety, about 8% of the bank. Try 6 below with full worked answers, then practise the rest in a timed mock.

Practice questions

Pick an answer to see why it's right, why the others are wrong, and the page in the book.

Q1. Work is being done beside a river. Why are life jackets preferred to buoyancy aids?

Show answer

Answer: D. They turn an unconscious person face upwards

  • Life jackets support an unconscious person and turn them face upwards; ideally auto-inflating and always worn.
  • Buoyancy aids help a conscious person but may not turn someone over.

Also provide a way to raise the alarm and rescue equipment.

Why the others are wrong:

A: anyone wearing a life jacket must be trained in its use.

B: life jackets do not keep people dry.

C: speed of swimming is not the point.

Memory trick:

Jacket turns you, aid just floats you.

Find it in the book

HSE HSG150 (3rd edition, 2006), page 102

Reg HSE HSG150, paras 523 and 524

Q2. Why should wet clothing not be draped over an electric heater in a site cabin?

Show answer

Answer: C. It can make the heater overheat and start a fire

  • Many fires have been caused by putting clothing on electrical heaters to dry, making them overheat.
  • Provide a proper drying area, separate from the eating area.

Heaters should have a high-temperature cut-out or be properly ventilated.

Why the others are wrong:

A: the risk HSG150 describes is fire, not contracts.

B: the concern is safety, not drying quality.

D: the hazard is overheating and fire.

Memory trick:

Heaters heat rooms, not coats.

Find it in the book

HSE HSG150 (3rd edition, 2006), page 14

Reg HSE HSG150, para 65

Q3. An RCD used to protect people should have a rated tripping current of no more than what?

Show answer

Answer: B. 30 mA

  • RCDs for protecting people have a rated tripping current of not more than 30 milliamps (mA).
  • Test it regularly with its test button and never bypass it.

An RCD detects some, but not all, faults and switches off quickly.

Why the others are wrong:

A: this is too high for personal protection.

C: this is ten times the sensitivity needed to protect people.

D: 13 A is a fuse rating, not an RCD sensitivity.

Memory trick:

Thirty milliamps keeps you alive.

Find it in the book

HSE INDG231 (rev1, 2012), page 3

Reg HSE INDG231, Provide a safety device

Q4. Why should you avoid running several tools from one socket with adaptors?

Show answer

Answer: C. Overloading sockets with adaptors can cause fire

  • Provide enough socket outlets: overloading sockets by using adaptors can cause fire.

New installations should be built to a suitable standard such as BS 7671 and maintained safely.

Why the others are wrong:

A: adaptors do not change the supply voltage.

B: this is not the hazard HSE describes.

D: overloading is a risk with any equipment.

Memory trick:

One socket, one plug.

Find it in the book

HSE INDG231 (rev1, 2012), page 2

Reg HSE INDG231, Ensure the electrical installation is safe

Q5. A gas heater is used inside a welfare cabin. What ventilation is needed?

Show answer

Answer: C. Fixed vents that cannot be closed off

  • Open-flued gas heaters can produce carbon monoxide with poor ventilation.
  • Use them only where vents or louvres give a permanent supply of fresh air that cannot be closed off.

LPG cylinders must be stored in the open air, in locked cages if needed.

Why the others are wrong:

A: a window is likely to be shut in cold weather.

B: the heater needs a permanent air supply.

D: an alarm does not replace the need for fresh air.

Memory trick:

Gas heater? Fixed vents, not windows.

Find it in the book

HSE HSG150 (3rd edition, 2006), page 13

Reg HSE HSG150, para 60

Q6. You are about to use a disc cutter that will throw sparks near a timber store. What fire precaution applies?

Show answer

Answer: D. Have a fire extinguisher to hand

  • Have an extinguisher to hand when doing hot work such as welding or using a disc cutter that produces sparks.
  • Keep flammable materials to a minimum near the work.

Check the area afterwards for smouldering material.

Why the others are wrong:

A: this does not provide a means of tackling a fire.

B: plastic sheeting can itself catch fire.

C: this does nothing to control a fire.

Memory trick:

Sparks fly? Extinguisher by.

Find it in the book

HSE HSG150 (3rd edition, 2006), page 18

Reg HSE HSG150, para 85

Want 194 more CITB Highway Works questions? Start a free timed mock.

Start a free mock

Full mock, no card needed. Full workouts on the first 5 questions.

Other CITB Highway Works topics

Free official guides for this topic

Our questions are written from these documents. Download them free to revise from the source.

© Crown copyright (DfT, HSE). Unchanged copies, reproduced under the Open Government Licence v3.0. FreeMocks is not connected to or endorsed by HSE or the government.

Revise this topic