Is BS 7671 statutory?

Updated 11 October 2026. Written by Acacio Oliveira, founder of FreeMocks, plumbing and heating engineer (F-Gas registered).

No. BS 7671, the IET Wiring Regulations, is a non-statutory British Standard. Parliament did not pass it, and breaking it is not by itself an offence.

That is only half the answer, though. Several laws that are statutory point straight at BS 7671, and if anything goes wrong, it is the yardstick your work will be measured against. This guide explains how that works and what to say in the exam.

Statutory and non-statutory: the difference

A statutory regulation is law, made under an Act of Parliament, and breaking it can lead to prosecution. A non-statutory document, like a British Standard or an HSE guidance note, sets out good practice. You are not legally bound to follow it, but you need a good reason not to, and you would have to show that what you did instead was at least as safe.

The laws that point to BS 7671

LawStatutory?How it links to BS 7671
Electricity at Work Regulations 1989YesHSE's guidance (HSR25) says installations that meet BS 7671 are likely to achieve compliance with the relevant regulations.
Electricity Safety, Quality and Continuity Regulations 2002YesRegulation 25 lets a distributor refuse to connect an installation that does not comply with BS 7671.
Building Regulations, Part P (England and Wales)YesApproved Document P gives following BS 7671 as the usual way to meet the requirement for safe electrical work in dwellings.
Building (Scotland) RegulationsYesThe Scottish technical handbooks refer to BS 7671 for electrical installations.
Electrical Safety Standards in the Private Rented Sector (England) Regulations 2020YesLandlords must have installations inspected and tested to the standard set out in the 18th Edition, at least every five years.

What it means on site

If you follow BS 7671 and something goes wrong, you have strong evidence that you did what was reasonably practicable. If you didn't, you have to prove your method was just as safe, and the starting assumption will be against you.

BS 7671 also says so itself. Part 1 sets out its scope, and Appendix 2 lists the statutory regulations that apply alongside it. Exam questions often lift the wording from those sections.

What to say in the exam

  • BS 7671 is non-statutory. It is a British Standard published by the IET and BSI.
  • The Electricity at Work Regulations 1989 are statutory. BS 7671 is a way of meeting them.
  • The Memorandum of guidance on the EAWR (HSR25) and the IET Guidance Notes are non-statutory too.
  • Appendix 2 of BS 7671 is where the statutory regulations are listed.

Practise for it

Statutory and non-statutory regulations come up early in the 18th Edition exam and in the ECS health and safety test. Check you have them straight with a timed mock.

Frequently asked questions

Is BS 7671 a legal requirement?

No. BS 7671 is a non-statutory British Standard, so breaking it is not in itself a criminal offence. But several pieces of law refer to it, and following it is the accepted way to show you have met them.

Which regulations are statutory for electricians?

The main ones are the Electricity at Work Regulations 1989, the Electricity Safety, Quality and Continuity Regulations 2002, the Building Regulations (Part P in England and Wales), and the Health and Safety at Work etc. Act 1974. They are law. BS 7671 is the standard used to meet them.

Can you be prosecuted for not following BS 7671?

Not for breaking BS 7671 alone. But if work is unsafe you can be prosecuted under the Electricity at Work Regulations or the Building Regulations, and a court will look at whether you followed BS 7671 as evidence of whether you did enough.

Is the 18th Edition a legal requirement for landlords?

In effect, yes, in England. The Electrical Safety Standards in the Private Rented Sector (England) Regulations 2020 require landlords to have installations inspected and tested at least every five years, and they define the standard by reference to the 18th Edition of the Wiring Regulations.

Why do exams ask whether BS 7671 is statutory?

Because it is a basic point about how the industry is regulated. In the 18th Edition exam the expected answer is that BS 7671 is non-statutory, and the Electricity at Work Regulations are the statutory regulations it helps you comply with.

Related

Sources: BS 7671:2018 as amended (Part 1 and Appendix 2), HSE Memorandum of guidance on the Electricity at Work Regulations 1989 (HSR25), the Electricity Safety, Quality and Continuity Regulations 2002, Approved Document P and the Electrical Safety Standards in the Private Rented Sector (England) Regulations 2020. This is general information, not legal advice. FreeMocks is independent and not affiliated with the IET, BSI or HSE.